Dock for Square Reader

There are two generations of Square Reader: Square Reader (1st generation) and Square Reader (2nd generation). Before purchasing a dock for your reader, you should identify your Square Reader to make sure you choose a compatible dock.

Both docks are sold separately via Square Shop:

• The white Dock for Square Reader (1st generation) is no longer available for sale and is only compatible with the Square Reader (1st generation).

• The grey Bosstab Dock is compatible with both generations of Square Reader –- Square Reader (1st generation) and Square Reader (2nd generation).

Square Reader (2nd generation) with Bosstab Dock for Square Reader (sold separately).

Square Reader (1st and 2nd generation) troubleshooting

To get started with the dock:

1. Locate the two buttons on either side of the outside cover. Push the two buttons simultaneously and slide the cover upwards to remove it. 

2. Place your Square Reader with the card slot facing downwards along the slope. The charging port and power button should be aligned with the higher part of the dock.

3. Place the outer cover back on until the cover clicks to lock into place.

4. Plug the power cable to the back of your Square Reader through the access opening in the back of the dock.

Note: The USB cord included with the Square Reader measures 0.8 metres. You can purchase an extended 2 metre cable in the Square Shop.

Dock for Square Reader (1st generation)

The Dock for Square Reader (1st generation) allows you to accept payments while keeping the reader charged and secure.

Note: The Dock for Square Reader (1st generation) is no longer available for sale and is only compatible with Square Reader (1st generation).